網站公告:

新聞中心

濟南精拓流體設備有限公司

電話:0531-69951198

郵箱:jingtuolt@163.com

傳真:0531-69951198

地址:濟南市歷城區西周南路9號

網址:http://www.vitagia.com

企業動態

當前位置:首頁 - 新聞中心 - 企業動態 - 氣體增壓泵工作原理及使用

氣體增壓泵工作原理及使用注意事項!

發布時間:2021-10-11 11:52:13   發布人:http://www.vitagia.com
氣體增壓泵是以壓縮空氣為動力源的一種活塞式增壓泵,當進氣時增壓氣控閥的閥芯往復切換工作,控制增壓泵活塞以極快的速度作往復動作,隨著輸出壓力的增高,活塞的往復速度減慢直至停止,此時,增壓泵輸出的壓力恒定,能量消耗低,各部件停止工作;無/何種原因造成保壓回路壓力下降,增壓泵將自動啟動,補充泄露壓力,保持回路壓力恒定。
The gas booster pump is a kind of piston booster pump with compressed air as the power source. When air is introduced, the valve core of the booster air control valve switches back and forth to control the booster pump piston to perform reciprocating action at a very fast speed. With the increase of output pressure, the reciprocating speed of the piston slows down until it stops. At this time, the output pressure of the booster pump is constant, the energy consumption is low, and all components stop working; If there is no reason for the pressure drop of the pressure maintaining circuit, the booster pump will start automatically to supplement the leakage pressure and keep the circuit pressure constant.
氣體增壓泵工作原理動態圖
Dynamic diagram of working principle of gas booster pump
1-驅動空氣入口;2-驅動空氣管路;3-氣動活塞;4-頂部撞針;5-先導閥口;6-換向閥;7-底部撞針;8-先導排氣口;9-消聲器;10-入口單向閥;11-出口單向閥
1 - drive air inlet; 2 - drive air pipeline; 3 - pneumatic piston; 4 - top striker; 5 - pilot valve port; 6 - directional valve; 7 - bottom striker; 8 - pilot exhaust port; 9 - silencer; 10 - inlet check valve; 11 - outlet check valve
氣動氣6增壓泵一般用于產品氣壓測試、提升工廠局部氣源壓力等,在一次使用前,須詳細閱讀產品相關使用說明,切勿憑感覺操作。使用時,注意以下事項等,可用的更久。
Pneumatic 6 booster pump is generally used for product air pressure test and increasing the local air source pressure of the factory. Before one use, read the relevant instructions of the product in detail and do not operate by feeling. When using, pay attention to the following matters, which will be available for a longer time.
1、使用的環境粉塵不能太多,因為氣動氣體增壓泵上的呼吸孔可能會把雜志吸入泵的腔體內6,進而可能會導致其上的密封圈機缸筒劃傷等情況的發生,大大的縮減應有的使用壽命年限。
1. The use of environmental dust should not be too much, because the breathing hole on the pneumatic gas booster pump may suck the magazine into the cavity 6 of the pump, which may lead to scratches on the sealing ring and cylinder barrel, greatly reducing the due service life.
2、如有條件的,可通過加配油水分離器來達到過濾掉空氣驅動氣源中的雜質以及水分等,這對于延長綜合使用年限都是很有幫助的。
2. If possible, add an oil-water separator to filter out impurities and moisture in the air driven air source, which is very helpful to prolong the comprehensive service life.
新聞推薦:
選擇氣動空氣增壓器要看品牌嗎? 2021-12-10
增壓泵自控閥由哪些部分組成? 2021-12-02
氣液增壓泵輸出力是怎么樣的? 2021-11-23
氣體增壓泵可以在哪些方面擴大使用了? 2021-11-20
氣體增壓機的典型應用 2021-11-07
氣動增壓泵與電動泵相比具有什么優點? 2021-10-19
氣體增壓泵工作原理及使用注意事項! 2021-10-11
溫度太低”對壓縮空氣增壓閥有什么影響? 2021-10-02
如何調節氣動液體增壓泵? 2021-09-24
氣動氣體增壓泵報價與什么因素有關? 2021-09-15

13188935873

qq

黑人巨茎大战俄罗斯美女